Toro Dingo 322, Руководство оператора

Страница: 18 / 40

Check Before Operating
16
7. Install the hood; refer to Installing the Hood,
page 26.
8. Remove and store the cylinder locks (refer to
Using the Cylinder Locks, page 22), and lower
the loader arms.
Checking the Hydraulic Fluid
Check the hydraulic fluid level before the engine is
first started and after every 25 operating hours.
Hydraulic Tank Capacity: 17.25 gal. (67 l)
Use only Group 1 ISO type 46/68 anti–wear
hydraulic fluids, recommended for ambient
temperatures consistently below 100
_
F (38
_
C), such
as Toro Hy–Pro, Mobil Fluid 424, or other equivalent
fluid.
IMPORTANT: Use only the group 1 ISO type
46/68 anti–wear hydraulic fluids. Other fluids
could cause system damage.
1. Remove the attachment, if one is installed; refer
to Removing an Attachment, page 24.
2. Park the traction unit on a level surface, raise the
loader arms, and install the cylinder locks; refer
to Using the Cylinder Locks, page 22.
3. Stop the engine and remove the key.
4. Remove the hood; refer to Removing the Hood,
page 26.
5. Clean the area around the filler neck of the
hydraulic tank (Fig. 8).
6. Remove the cap from the filler neck and check
the fluid level on the dipstick (Fig. 8).
The fluid level should be 1/2 to 3/8 inches (10 to
15 mm) below the mark on the dipstick when the
loader arms are raised. If the loader arms are
lowered, the fluid level should be at the mark on
the dipstick.
1
m–4392
2
Figure 8
1. Filler neck cap 2. Dipstick
7. If the level is low, add enough fluid to raise it to
the proper level.
8. Install the cap on the filler neck.
9. Install the hood; refer to Installing the Hood,
page 26.
10. Remove and store the cylinder locks (refer to
Using the Cylinder Locks, page 22) and lower
the loader arms.
Tire pressure
Maintain the air pressure in the tires as specified.
Check the tires when they are cold to get the most
accurate reading.
Pressure: 15–20 psi (103–138 kPa)
Note: Use a lower tire pressure (15 psi/
103 kPa) when operating in sandy soil
conditions to provide better traction in
the loose soil.
1
m–1872
Figure 9
1. Valve stem