Toro 79482, Руководство оператора

Страница: 14 / 28

14
m–6647
1
3
3
5
3
5
4
2
Figure 23
1. Hood—open position
2. Engine
3. Pivot peg
4. Wire harness
5. Harness connector
6. Connect the harness and close the hood (Fig. 23).
7. Install the belt cover onto the snowthrower (Fig. 54).
m–7071
2
1
Figure 24
1. Belt cover 2. Bolts
Installing the Chute Control
Rod and Support
1. Slide the crank support onto the mounting post on the
left-hand side of the tractor (Fig. 25).
2. Secure the crank support in position with a locking pin
and small hairpin cotter pin (Fig. 25).
1
3
2
m–7078
Figure 25
Left side of tractor shown
1. Crank support
2. Locking pin
3. Hairpin cotter, small
3. Slide the crank handle through the hole in the crank
support and secure the handle to the worm gear
assembly with a hairpin cotter pin (Fig. 26).
Note: Adjust the worm gear assembly if necessary so the
handle clears the tractor hood, the teeth mesh fully, and the
chute turns freely.
1
1
2
4
3
m–7122
Figure 26
1. Crank handle
2. Crank support
3. Worm gear assembly
4. Hair pin cotter pin