Toro 74513, Руководство оператора

Страница: 28 / 64

Premaintenance
Procedures
Releasing the Cushion for
Rear Access
You can release the cushion for rear access to the machine for
maintenance or adjustment.
1. Lower the platform.
2. Loosen the twist knobs on each side of the machine
(
Figure 33 ).
Figure 33
1. Twist knob
2. Cushion
3. Remove the cushion and lower it to the platform.
4. Perform any maintenance or adjustment on the
machine.
5. Raise the cushion, and slide it onto the pins on both
sides of the machine.
6. Tighten the twist knobs.
Lubrication
Grease with No. 2 lithium or molybdenum grease.
1. Disengage the PTO and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag.
Note:
Make sure to scrape any paint off the front of
the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
6. Wipe up any excess grease.
Greasing the Accessory Frame
Grease the pivots of the accessory frame at the locations
shown in
Figure 34 .
Figure 34
1. Grease these pivots.
28