Toro 74513, Руководство оператора

Страница: 23 / 64

WARNING
Loading a machine onto a trailer or truck increases
the possibility of tip-over and could cause serious
injury or death.
• Use extreme caution when operating a machine
on a ramp.
• Use only a full-width ramp; do not use individual
ramps for each side of the machine.
• Do not exceed a 15-degree angle between the
ramp and the ground or between the ramp and
the trailer or truck.
• Ensure that the length of the ramp is at least 4
times as long as the height of the trailer or truck
bed to the ground. This will ensure that the
ramp angle does not exceed 15 degrees on flat
ground.
• Back the machine up the ramp and walk it
forward down the ramp.
• Avoid sudden acceleration or deceleration while
driving the machine on a ramp, as this could
cause a loss of control or a tip-over situation.
g027996
5
1
2
6
Figure 26
1. Full-width ramp in stowed
position 4. The ramp is at least 4
times as long as the height
of the trailer or truck bed
to the ground
2. Side view of full-width
ramp in loading position 5. H= height of the trailer or
truck bed to the ground
3. Not greater than
15 degrees 6. Trailer
23