Toro 60217, Руководство оператора

Страница: 25 / 56

g019747
Figure 31
Model 60221HD shown
7. After the engine starts, gradually move the
choke lever back to the O
FF
position. If the
engine stalls or hesitates, move the choke back
to the O
N
position again until the engine warms
up. Then move it to the O
FF
position.
Shutting Off the Engine
1. Move the throttle lever to the M
IN
position
( Figure 10 ).
Note:
If the engine has been working hard or
is hot, let it idle for a minute before shutting off
the engine. This helps to cool the engine before
stopping. In an emergency, shut off the engine
immediately.
2. Move the engine switch to the O
FF
position.
3. Move the fuel valve to the C
LOSED
position, all
the way to the left.
Mixing the Material
DANGER
Eye and skin contact with concrete materials
and breathing the dust involved is hazardous
to your health.
• Ensure that there is adequate air
ventilation.
• Wear a dust mask to prevent inhalation of
dust while using the machine; refer to
Safe
Operating Practices (page 5) .
• Avoid direct contact of cement and
concrete materials with skin and eyes.
DANGER
This machine is capable of amputating hands.
• Stay in the operator’s position while the
machine is running.
• Keep all bystanders a safe distance away
from the machine.
• Stop the machine immediately if any
people or animals enter the work area.
• Never place any part of your body into a
position that causes an unsafe operating
condition.
Important:
Do not add more material than
the batch capacity of the machine; refer to
Specifications (page 17) .
Note:
Follow the manufacturer’s instructions that are
printed on the packaging of the product you are using.
1. Ensure that there is no old, loose material in
the drum that can contaminate the batch of
material; refer to
Cleaning the Drum (page 27)
and Dumping the Material (page 26) , then return
the drum to the upright position.
Note:
Ensure that the drum is in the mix
position (upright) and the drum latch is engaged.
2. Move the clutch lever to the O
FF
position ( Figure
32 ).
3. Start the engine.
Note:
Allow the engine to warm up at 2/3
throttle for 1 to 2 minutes.
4. Set the throttle lever on the engine to the M
AX
position.
5. Move the clutch lever to the O
N
position ( Figure
32 ).
25