Toro 58630, Руководство оператора

Страница: 20 / 77

Storage
Storage Safety
•
Shut off the machine and wait for all moving parts
to stop before you leave the operator’s position.
Disconnect the spark-plug wire, keep it away from
the plug to prevent accidental starting, and allow
the machine to cool before adjusting, fueling,
unclogging, servicing, cleaning, or storing the
machine.
•
Run the engine dry or remove the fuel with a hand
pump; never siphon the fuel. If you must drain the
fuel tank, do it outdoors.
•
Follow the instructions in this Operator’s Manual
to safely unload, transport, and store the machine.
•
Do not store the machine with fuel in the fuel
tank inside a building where ignition sources are
present, such as hot water and space heaters and
clothes dryers. Allow the engine to cool before
storing the machine in an enclosure.
•
Always refer to the Operator’s Manual for
important details if the machine is to be stored for
an extended period.
Cleaning and Storing the
Machine
1. Shut off the engine and wait for all moving parts
to stop before leaving the operating position.
2. Remove all debris from the auger and engine.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
engine and powerhead.
3. Service the air filter; refer to Servicing the Air
Filter (page 15) .
4. Prepare the machine for storage for over
30 days as follows:
A. Add fuel stabilizer/conditioner to fresh fuel
in the tank. Follow mixing instructions from
the fuel stabilizer manufacturer. Do not
use an alcohol-based stabilizer (ethanol or
methanol).
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and
drain the fuel tank.
D. Start the engine and run it until it shuts off.
E. Dispose of fuel properly. Recycle the fuel
according to local codes.
Important:
Do not store fuel containing
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer.
5. Remove and check the condition of the spark
plug; refer to
Servicing the Spark Plug (page 16) .
With the spark plug removed from the engine,
pour 15 ml (1 tablespoon) of engine oil into the
spark plug hole. Install the spark plug and pull
the recoil rope 3 times to coat the cylinder with
oil. Do not install the wire on the spark plug.
6. Check and tighten all fasteners. Repair or
replace any part that is damaged.
7. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
8. Store the machine in an secure, upright position
in a clean, dry garage or storage area. Keep it
out of reach of children or other unauthorized
users. Cover the machine to protect it and keep
it clean.
18