Toro 41245, Руководство оператора

Страница: 6 / 12

Figure 7
1. Flange nut (3/8 inch) 3. Short bolt (3/8 inch)
2. Small washer
8. Install the large washer and spring pin to the underside
of the hose-reel frame (
Figure 8 ).
Figure 8
1. Large washer 2. Spring pin
9. Connect the remaining wiring harness plugs to the
motor, the main-harness power, and the hose reel kit
plugs.
4
Installing the Control Valve
Parts needed for this procedure:
1 Control valve
1 Hose-reel supply hose
1 Gasket clamp
1 Straight, barbed fitting
1 Shut-off valve
1 Female cap
1 Fitting
Procedure
1. Remove the retainer that secures the a actuator to the
manifold valve for the section valve or agitation valve
(
Figure 9 ).
Note:
Squeeze the 2 legs of the retainer together while
pushing it down.
Note:
Retain the actuator and retainer.
Figure 9
1. Actuator 3. Stem port
2. Retainer
2. Remove the actuator from the manifold valve.
3. Remove the retainers holding the bypass-valve cluster
for the boom, the end cap, and the fitting and hose
assembly as shown in
Figure 10 .
Note:
You will not use the male cap, but keep the
O-ring that is on the cap.
6