Toro 41245, Руководство оператора

Страница: 7 / 12

1
2
3
2
g029410
Figure 10
1. End cap 3. Fitting and hose assembly
2. Retainers
4. Note the current settings on the left and right knobs.
5. Rotate the boom bypass valve cluster 180 degrees as
shown in
Figure 11 .
Figure 11
1. Bypass-valve cluster for the boom
6. Adjust the left and right knobs to the settings that you
noted in step
4 .
7. Install the bypass-valve cluster for the boom, the
female cap, O-rings, shutoff valve, and fitting and hose
assembly using the retainers previously removed as
shown in
Figure 12 .
Figure 12
1. Female cap 2. Shutoff valve
8. Disconnect the cap and coupler from the
pressure-gauge port (
Figure 13 ).
Figure 13
1. Gasket 4. Coupler
2. 90-degree fitting 5. Control valve
3. Gasket clamp
6. Hose-reel supply hose
9. Install the control-valve assembly as shown in Figure
13 .
10. Install the coupler into the open port on the 90-degree
fitting (
Figure 13 ).
Note:
Discard the cap.
11. Connect the hose-reel supply hose to the control valve
using a hose clamp.
12. Secure the straight, barbed fitting to the open end of
the hose-reel supply hose with a hose clamp.
13. Route the hose-reel supply hose as shown in Figure 14
and attach it to the hose reel with a hose clamp.
7