Toro 41245, Руководство оператора

Страница: 8 / 12

Note:
If the Tank Cleanse Rinse Kit is installed, route
the hose behind the rinse pump.
Figure 14
1. Tank-supply hose 2. Hose-reel supply hose
14. Secure the wiring harness to the supply hose using
2 cable ties.
5
Connecting the Spray Hose
Parts needed for this procedure:
1 Long hose with fitting
1 Spray gun
1 Small hose clamp
Procedure
1. Wrap Teflon® tape around the threads of the hose
fitting on the long hose, and install the fitting into the
connecting tube on the reel (
Figure 15 ).
Figure 15
2. Connect the free end of the long hose to the fitting on
the spray gun (
Figure 16 ).
g017765
1
2
3 4
Figure 16
1. Hose 3. Barb
2. Hose clamp 4. Spray gun
3. Secure the end of the hose with a small hose clamp.
4. Connect the terminal of the negative battery cable to
the battery.
5. Press the H
OSE
-
WIND
button, and carefully guide the
hose onto the reel moving the hose from side to side to
evenly distribute the hose.
CAUTION
Hands, loose clothing, long hair, and jewelry
could get caught in the hose and reel while
rewinding and cause injury.
• Keep your hands clear of the reel and hose
while it is rewinding.
• Do not wear loose clothing or jewelry and
tie up long hair.
8