Note:
If you make a data entry error, reset the
console computer by turning the power switch to
the Off position and, while pressing and holding
the [CE] key, turning the power switch to the On
position.
Selecting SP3
1. Press the [CE] key until you see SP3.
Note:
SP1 is for wheel drive and SP2 is for radar
speed drive and are not used. For your console
computer, the SP3 (gear tooth drive) is the proper
setting.
2. Press the [Enter] key.
Note:
The display shows 0 in the right hand
window. Left hand window will still be showing
CAL until buttons 1-8 have data entered.
3. To program the computer console, refer to
Programming the Console Computer.
Note:
All the data is retained when you turn the power
switch to the Off position.
Programming the Console
Computer
Important:
Ensure that the boom bypass valves
are closed.
Move the power switch on the console computer to
the On position.
Note:
Turning the power switch to the Off position
or disconnecting the console cables does not erase the
data stored in the console computer memory.
Important:
The calibration figures given are
guidelines only; you should perform calculations
for your particular machine and spraying
application situation and conditions.
Note:
Refer to Figure 13 and the Keypad Reference
Table for the description and function of the keys on
the console computer.
Calculating the Boom Cal Data
Calculate the Boom Cal by multiplying the number of
spray tips by the tip spacing.
Note:
Boom 1 is the left boom (from the operating
position), Boom 2 is the center boom, and Boom 3 is
the right boom.
1. Press the [Boom 1 Cal] key.
2. Press the [Enter] key.
3. Enter
80
.
4. Press the [Enter] key.
5. Press the [Boom 2 Cal] key.
6. Press the [Enter] key.
7. Enter
60
.
8. Press the [Enter] key.
9. Press the [Boom 3 Cal] key.
10. Press the [Enter] key.
11. Enter
80
.
12. Press the [Enter] key.
Entering the SPEED Cal Number
The SPEED Cal number is critical to the performance
of the spray system. Ensure that the tires are properly
inflated and that the tank is half full before performing
this procedure.
1. Press the [SPEED Cal] key.
2. Press the [Enter] key.
3. Enter correct SPEED Cal number for your current
selected unit of measurment (US, SI, TU).
•
When using US units enter:
148
.
•
When using SI units enter:
38
.
•
When using TU units enter:
148
4. Press the [Enter] key.
Note:
These numbers allow the machine to operate
with reasonable accuracy. Fine tuning is necessary for
maximum accuracy.
The following procedure requires buttons 1-8 to have
been populated with data and CAL to stop flashing.
Use the following procedure to further fine tune the
SPEED Cal number
1. Measure 500 feet on a flat ground surface.
2. Set the distance readout to
0
.
3. Press the [Distance] key.
4. Press the [Enter] key.
5. Enter
0
.
6. Press the [Enter] key.
7. Drive the vehicle 500 feet.
8. Ensure that the distance readout on the console
computer reads between 490 and 510 feet.
9. If the readout is not between 490
and 510 feet, calibrate the SPEED
Cal using the following equation:
12
