Toro 31598N, Руководство оператора

Страница: 40 / 68

Figure 48
1. Slide cover inward
approximately 1 inch 2. Disengage these cover
edges
6. Lift the front edge, guide it between the lift arm and
the roller to remove it (
Figure 49 ).
Figure 49
1. Slide cover out between lift arm and roller
Installation
1. Lower the wing deck onto a level surface.
2. Slide the cover into position by guiding the rear edge
between the lift arm and roller.
3. While sliding the cover away from the traction unit,
guide the outside edge under the front and rear brackets
on the deck.
4. Align the deck mounting posts with the holes in the
cover and lower the cover into position.
5. Install the bolt securing the belt cover, if so equipped.
6. Engage the deck cover latch.
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Before each use or daily—Lubricate castor
arm bushings.
Every 50 hours—Lubricate all grease fittings.
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
If the machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation or
immediately after every washing.
Note:
The castor fork shaft bushings must be lubricated
before each use or daily
The grease fitting locations and quantities are:
Traction Unit
•
Impact arms (2) ( Figure 50 )
•
Front Deck Lift cylinder pivots (2) ( Figure 50 )
•
Side Deck Lift cylinder pivots (2) ( Figure 50 )
•
Steering cylinder ball joints (4) ( Figure 51 )
•
Tie rod ball joints (2) ( Figure 51 )
•
King pin bushings (2) ( Figure 51 )
•
Rear axle pivot bushing (1) ( Figure 52 )
•
Brake shaft pivot bearings (1) ( Figure 53 )
40