Toro 31598N, Руководство оператора

Страница: 17 / 68

Note:
Make sure to slide the cover under the front
center deck cover tabs before inserting it onto the
mounting hooks and post.
9. Repeat the procedure on the other winglet.
Figure 6
1. Cover 3. Front center deck cover
tabs
2. Rubber latch 4. Mount hooks
3
Leveling the Front Center Deck
No Parts Required
Procedure
Refer to Adjusting the Height-of-Cut in Operation.
1. Rotate blade on each outer spindle until the ends face
forward and backward.
2. Measure from the floor to the front tip of the blade.
Adjust the 1/8 inch shims on the front castor fork(s)
to match the desired height of cut.
3. Rotate the blades 180° and now measure from the floor
to the (rear facing) tip of the blade.
4. Loosen the lower jam nuts on the height-of-cut chain
U-bolt.
5. Adjust the nuts to raise or lower the rear of the cutting
unit so that the front and rear blade tips have the same
measurement. Tighten the jam nuts.
6. Proceed to procedure 4 and level the winglet decks to
the front center deck.
4
Leveling the Winglet Decks to
the Front Center Deck
No Parts Required
Procedure
Level the winglet decks to the front deck as follows:
•
Rotate the blade on each winglet so that it points side
to side.
•
Loosen the bolts and nuts securing the two eccentric
spacers to the winglets (
Figure 7 ).
Figure 7
1. Winglet 4. Eccentric
2. Hinge pin 5. Upper hole
3. Stop bolt
•
Rotate the rear (closest to traction unit) eccentric until the
outside blade tip is about 3 mm (1/8 inch) higher than
the desired height of cut (
Figure 7 ).
Note:
There is a notch on the eccentric hex which is
180° from the lobe on the eccentric cam ( Figure 8 ). Use
the notches to reference the location of the lobes when
adjusting the eccentrics.
17