Toro 30639, Руководство по установке

Страница: 8 / 12

Figure 13
1. Rear bumper bracket bolts and nuts
2. Using the bolts and nuts previously removed, secure a
lamp assembly to the bracket and frame (
Figure 14 ).
G016538
1
2
3
4
5
Figure 14
1. Nuts previously removed 4. Rear lamp assembly
2. Rear bumper bracket 5. Bolts previously removed
3. Cable tie
3. Repeat the procedure on the other side of the machine.
4. Following the traction unit main wiring harness, route
the rear light wiring harness to the right rear lamp as
follows:
•
Under the hood support bracket ( Figure 15 ).
•
Under the valve ( Figure 15 ).
•
Along the existing hard line and wiring harness to
the radiator support (
Figure 15 ).
•
Over the radiator hose ( Figure 15 )
•
Down under the frame shroud ( Figure 15 )
Figure 15
1. Hood support bracket 4. Radiator hose
2. Valve 5. Frame shroud
3. Radiator support
•
Affix a cable tie mounting pad to the under side of
the frame, behind the rear axle and approximately
7 inches (17.8 cm) from the right frame rail (
Figure
16 ).
Important:
Make sure the mounting surface is
cleaned with rubbing alcohol before installing
the mounting pad. Press and hold the
mounting pad for 15 seconds when installing.
8