Toro 30635, Руководство оператора

Страница: 39 / 60

Lubrication
Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 general-purpose lithium-base grease. If
the machine is operated under normal conditions, lubricate all
bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2) ( Figure 35 )
•
Front and rear axle pivot bushings (2) ( Figure 36 )
•
Steering cylinder ball joints (2) ( Figure 37 )
•
Tie rod ball joints (2) ( Figure 37 )
•
King pin bushings (2) ( Figure 37 ).
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 35
Figure 36
Figure 37
Front Cutting Unit
•
Castor fork shaft bushings (2) ( Figure 38 )
•
Spindle shaft bearings (3) (located under the pulley)
(
Figure 39 )
•
Idler arm pivot bushings (2) ( Figure 39 )
Figure 38
39