Electrical System
Maintenance
Battery Care
Battery type is group 24.
Important:
Before welding on the machine, disconnect
the negative cable from the battery to prevent damage to
the electrical system.
Note:
Check the battery condition weekly or after every
50 hours of operation. Keep the terminals and the entire
battery case clean because a dirty battery will discharge slowly.
To clean the battery, wash the entire case with a solution
of baking soda and water. Rinse with clear water. Coat
the battery posts and cable connectors with Grafo 112X
(skin-over) grease (Toro Part No. 505-47) or petroleum jelly
to prevent corrosion.
1.
Open the battery cover (
). on the side of
the shroud.
Note:
Press down on the flat surface above the battery
cover to ease cover removal (
2
g020758
Figure 53
1.
Battery cover
2.
Press down here
Figure 54
1.
Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
2.
Remove the rubber boot from the positive terminal
and inspect the battery.
WARNING
Battery terminals or metal tools could short
against metal components causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
•
When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
•
Do not allow metal tools to short between
the battery terminals and metal parts of
the machine.
WARNING
Incorrect battery cable routing could damage
the machine and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
•
Always
disconnect
the negative (black)
battery cable before disconnecting the
positive (red) cable.
•
Always
connect
the positive (red) battery
cable before connecting the negative
(black) cable.
3.
Coat both battery connections with Grafo 112X
(skin-over) grease, Toro Part No. 505-47, petroleum
jelly, or light grease to prevent corrosion. Slide the
rubber boot over the positive terminal.
4.
Close the battery cover.
Fuses
The traction unit fuses (
thru
) are located
under the power center cover.
Remove the 2 Allen head screws securing the power center
cover to the frame and remove the cover (
).
44
Содержание 30635
Страница 14: ...130 6043 1 Read the Operator s Manual 14 ...
Страница 15: ...130 6046 1 Read the Operator s Manual 15 ...