Toro 30604, Руководство оператора

Страница: 38 / 60

Lubrication
Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 general-purpose, lithium-based grease. If
the machine is operated under normal conditions, lubricate all
bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2) ( Figure 35 )
•
Front and rear axle pivot bushings (2) ( Figure 36 )
•
Steering cylinder ball joints (2) ( Figure 37 )
•
Tie rod ball joints (2) ( Figure 37 )
•
King pin bushings (2) ( Figure 37 ).
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 35
Figure 36
Figure 37
Center Cutting Unit
Note:
Deck may have to be raised to expose the grease
fittings for the latch pivot and the lower link.
Latch pivot (2) ( Figure 39 )
Note:
The latch ( Figure 38 ) may need to be manually tripped
to gain access to the grease fitting. Use a prybar to close and
re-open the latch
Figure 38
1. Latch
38