Toro 30604, Руководство оператора

Страница: 28 / 60

Figure 16
4. Push the castor spindle through the front castor arm.
Install the shims (as they were originally installed) and
the remaining spacers onto the spindle shaft. Install the
tensioning cap to secure the assembly.
5. Remove the hairpin cotter and clevis pin securing the
height-of-cut chains to the rear of the cutting unit
(
Figure 17 ).
1
2
g020968
Figure 17
1. Height-of-cut chain 2. Clevis pin and hair pin
cotter
6. Mount the height-of-cut chains to the desired
height-of-cut hole (
Figure 18 ) with the clevis pin and
hairpin cotter.
Figure 18
Note:
When using 25 mm (1 inch), 38 mm (1-1/2
inch), or occasionally 51 mm (2 inch) height-of-cut,
move the skids and gage wheels to the highest position.
Wing Cutting Units
To adjust the height-of-cut on the side cutting units, add
or remove an equal number of spacers from the castor
forks, position the castor wheel axles in the high or low
height-of-cut holes in the castor forks, and secure the pivot
arms to the selected height-of-cut bracket holes.
1. Position the castor wheel axles in the same holes in all
of the castor forks (
Figure 19 and Figure 21 ). Refer to
the following chart to determine the correct hole for
the setting.
2. Remove the tensioning cap from the spindle shaft
(
Figure 19 ) and slide the spindle out of castor arm. Put
the two shims (3 mm [1/8 inch]) onto spindle shaft as
they were originally installed. These shims are required
to achieve a level across the entire width of the cutting
units. Slide the appropriate number of 13 mm (1/2
inch) spacers onto the spindle shaft to get the desired
height-of-cut; then slide the washer onto the shaft.
Figure 19
1. Tensioning cap 4. To axle mounting hole
2. Spacers 5. Castor wheel
3. Shims
Refer to the following chart to determine the
combinations of spacers for the setting.
Figure 20
28