Toro 30460, Руководство оператора

Страница: 10 / 32

7
Installing the Handle Assembly
Parts needed for this procedure:
1 Handle assembly
1 Pin
2 Roll pin
Procedure
1. Position the handle assembly onto the handle mount
assembly (
Figure 10 ).
2. Secure the handle assembly with a pin and a roll pin
(
Figure 10 ).
Figure 10
1. Handle assembly 3. Pin
2. Roll pin 4. Handle mount assembly
8
Installing the Bagger
Assembly
Parts needed for this procedure:
1 Bagger assembly
2 Pin and hairpin cotter pin assembly
2
Nut (3/8 inch)
1 Threaded rod
2 Yoke
2
Clevis pin spring
Procedure
Note:
After installing the bagger, open the bagger door and
remove the discharge tubes.
1. Position the bagger on its back ( Figure 11 ).
2. Slide the hooks onto the lower mounting bracket
(
Figure 11 ).
3. Rotate the bagger up on the lower bagger mounting
bracket.
4. Align the hole in the bagger with the upper mounting
bracket (
Figure 11 ).
5. Install the pin and secure it with the hairpin cotter pin
on both sides (
Figure 11 ).
10