Toro 30433, Руководство оператора

Страница: 37 / 64

Figure 44
1. Fuse, 25 amp, blade type 2. Fuse, 30 amp, blade type
Drive System
Maintenance
Perform the following linkage adjustments when
the machine needs maintenance. Perform steps
Adjust the Speed Control Linkage through
Adjusting the Tracking. If and adjustment is
needed , do them in the order that they are listed.
Adjusting the Speed Control
Linkage
1. Disengage the PTO and set the parking brake.
2. Stop the engine and wait for all moving parts
to stop before leaving the operating position.
3. Move the speed control lever (located on the
console) to the full forward position.
Figure 45
1. Speed control lever 4. Medium speed position
2. Full speed position 5. Control panel
3. Neutral position
4. Check the orientation of the tabs on the ends
of the speed control crank. These tabs should
be pointing straight down at the 6 o’clock
position approximately (Figure 46).
5. If adjustment is needed, loosen the nuts on
both sides of the swivel on the speed control
rod (Figure 46).
6. Adjust the swivel until the tabs are at the
6 o’clock position (Figure 46).
7. Tighten the nuts on both sides of the swivel
(Figure 46).
Figure 46
1. Speed control rod 4. Tabs, 6 o’clock position
2. Jam nut 5. Swivel
3. Speed control crank
8. Pull the speed control lever back to neutral.
9. Check the travel of the shift lever in the control
panel slot. The shift lever travel should be
approximately centered in the control panel
slot (Figure 47).
10. If needed, adjust the swivel on the speed
control rod to center the shift lever travel
(Figure 46).
11. With the speed control lever in the neutral
position, check to make sure the safety switch
is depressed and there is an 1/8 to 1/4 inch (3
to 6 mm) space between the actuating tab and
the safety switch (Figure 47)..
37