Toro 30433, Руководство оператора

Страница: 16 / 64

Step
6
Installing the Hairpin Cotter
Pins and Spacers
Parts needed for this step:
2 Hairpin cotter pin
6 Spacers
Procedure
Store unused height-of-cut spacers on posts and
retain them by a hairpin cotter.
Note:
Make sure there is at least one spacer used
on each height-of-cut post.
1. Remove the existing rear hairpin cotter pins
from the rear height-of-cut posts (Figure 12).
2. Install a spacer onto both rear height-of-cut
posts and install the hairpin cotter pins
(Figure 12).
Figure 12
1. Hairpin cotter 3. Height-of-cut post (rear
shown)
2. Spacer
3. Install a spacer onto both front height-of-cut
posts and install the hairpin cotter pins.
4. On the opposite side of the muffler,
install unused spacers onto front and rear
height-of-cut pins and insert the hairpin cotter
pins (Figure 13).
Figure 13
1. Hairpin cotter 3. Height-of-cut post (front
shown)
2. Unused spacers
Step
7
Checking the Hydraulic
Fluid and Engine Oil Level
No Parts Required
Procedure
Before you start the engine do the following:
• check the oil level in the engine crankcase;
refer to Checking the Engine Oil Level.
• check the hydraulic fluid level in the engine
crankcase; refer to Checking Hydraulic the
Fluid Level.
16