Toro 30433, Руководство оператора

Страница: 15 / 64

Figure 9
1. Control rod 4. E-ring
2. Rod tting 5. Control arm
3. 2–1/2 inch (63.5 mm) from
the bottom
3. Place the clevis pin into the control rod, drive
lever and neutral lock (Figure 10).
4. Install the hairpin cotter between the drive
levers and the neutral locks and into the clevis
pins (Figure 10).
Figure 10
1. Control rod 5. Left handle shown
2. Clevis pin 6. Neutral lock
3. Drive lever
7. Hairpin cotter pin
4. Operator Presence Control
lever (OPC)
Step
5
Install the Speed Control
Rod
Parts needed for this step:
1 Washer
1 Cotter pin
Procedure
Install the swivel into the speed control crank and
secure it with a washer and cotter pin (Figure 11 ).
Note:
If necessary, move the speed control lever
until the swivel will go into the speed control
crank.
Figure 11
1. Speed control rod 4. Speed control crank
2. Swivel 5. Cotter pin
3. Nut
6. Washer
15