26
4. Gently slide the primary filter out of the air cleaner
body (Fig. 23). Avoid knocking the filter into the side
of the body. Do not remove the safety filter, unless you
intend to replace it as well.
5. Inspect the primary filter for damage by looking into
the filter while shining a bright light on the outside of
the filter. Holes in the filter will appear as bright spots.
If the filter is damaged, discard it, otherwise clean it.
Important
Never attempt to clean the safety filter. If
the safety filter is dirty, then the primary filter is damaged
and you should replace both filters.
4
3
m–4387
5
1
2
1
Figure 23
1.
Latches
2.
Air cleaner cover
3.
Air filter body
4.
Primary filter
5.
Safety filter
Cleaning the Primary Filter
Blow compressed air from the inside to the outside of the
primary filter.
Important
Do not exceed 100 psi. and keep the hose
at least 2 in. from the filter.
Installing the Filters
1. If installing new filters, check each filter for shipping
damage. Do not use a damaged filter.
2. If the safety filter is being replaced, carefully slide it
into the filter body (Fig. 23).
3. Carefully slide the primary filter over the safety filter
(Fig. 23). Ensure that it is fully seated by pushing on
the outer rim of the filter while installing it.
Important
Do not press on the soft inside area of the
filter.
4. Install the air cleaner cover with the side indicated as
UP facing up and secure the latches (Fig. 23).
Servicing the Engine Oil
Change oil after the first 50 operating hours and then
every 100 operating hours thereafter.
Note: Change oil more frequently when operating
conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SH, SJ, SL, or
higher)
Crankcase Capacity: w/filter, 2.1 qt. (2 l)
Viscosity: See table below
F
–20
0
20
40
60
80
100
°
C
–30
°
–20
–10
0
10
20
30
40
USE THESE SAE VISCOSITY OILS
32
5W-20, 5W-30
10W-30, 10W-40
Changing the Oil
1. Start the engine and let it run for five minutes. This
warms the oil so it drains better.
2. Park the traction unit so that the drain side is slightly
lower than the opposite side to ensure that the oil
drains completely.
3. Lower the loader arms, chock the wheels, and stop the
engine. Remove the key.
Components will be hot if the traction unit has
been running. If you touch hot components you
may be burned.
Allow the traction unit to cool before performing
maintenance or touching components under the
hood.
Caution
4. Place one end of a hose on the drain valve and the
other end in a pan.
5. Open the drain valve by turning it counterclockwise,
pulling out as you turn it (Fig. 24).
6. When the oil has drained completely, close the drain
valve and remove the hose.
