To slow or stop, move the traction control levers
to neutral.
Attachment Tilt Lever
To tilt the attachment forward, slowly push the
attachment tilt lever forward.
To tilt the attachment rearward, slowly pull the
attachment tilt lever rearward.
Loader Arm Lever
To lower the loader arms, slowly push the loader
arm lever forward.
To raise the loader arms, slowly pull the loader
arm lever rearward.
Loader Valve Lock
The loader valve lock secures the loader arm and
attachment tilt levers so that you cannot push
them forward. This helps to ensure that no one
will accidentally lower the loader arms during
maintenance. Secure the loader arms with the lock
anytime you need to stop the machine with the
loader arms raised.
To set the lock, pull it back and all the way down
against the levers (Figure 7).
Note:
You will need to move the levers rearward
to engage or disengage the loader valve lock.
Figure 7
1. Loader valve lock, engaged 2. Loader valve lock,
disengaged
Auxiliary Hydraulics Lever
To operate a hydraulic attachment in a forward
direction, push the lever to the left, out of the
neutral slot, and slowly pull the auxiliary hydraulics
lever rearward.
To operate a hydraulic attachment in reverse
direction, push the lever to the left, out of
the neutral slot, and slowly push the auxiliary
hydraulics lever forward. You can also set the
lever so that the reverse hydraulics are on without
operator presence. To do so, move the lever
completely to the left and then forward until the
lever remains in the reverse position.
Speed Selector Lever
Move the speed selector lever to the fast (rabbit)
position to set the traction drive, loader arms, and
attachment tilt to high speed and the auxiliary
hydraulics to low speed.
Move the speed selector lever to the slow (turtle)
position to set the auxiliary hydraulics to high
speed and the traction drive, loader arms, and
attachment tilt to low speed.
If you move the speed selector lever while
the traction unit is in motion, the traction
unit will either stop suddenly or accelerate
quickly. If you operate the traction unit with
the speed selector lever in an intermediate
position, the traction unit will operate
erratically and may be damaged. You could
lose control of the traction unit and injure
bystanders or yourself.
•
Do not move the speed selector lever
when the traction unit is in motion.
•
Do not operate the traction unit when
the speed selector is in any intermediate
position (i.e., any position other than
fully forward or fully rearward).
Hour Meter
The hour meter displays the number of hours of
operation that have been logged on the traction
unit.
After 50 hours and every 75 hours thereafter (that
is at 50, 125, 200, etc.) the hour meter displays
SVC on the lower left side of the screen to remind
you to change the oil and perform the required
maintenance. After every 400 hours (400, 800,
1200, etc.), the hour meter displays SVC on the
lower right side of the screen to remind you to
perform the maintenance procedures based on
a 400 hour schedule. These reminders come on
14
Содержание 22303 Dingo 320-D
Страница 7: ...Slope Chart 7...
