Step 3; See Figure 3A & 3B:
Install right and left Rear Posts (1 & 2).
A.
Use three 3/8” x 1” bolts and 3/8” flange
locknuts to fasten the right Rear Post to the
machine as shown.
B.
Repeat this step on the left side with the left
Rear Post.
Figure 3A
1
2
C. Tighten the bolts to R.O.P.S. torque
specifications.
IMPORTANT !
If a ROPS bar is in place remove the bolts from
the ROPS bar and attach the rear posts on top
of the ROPS bar using the 3/8” x 1” bolts and
3/8” flange nuts.
Figure 3B
Step 4; See Figure 4:
A
Install the Dash Support Bracket (14).
A.
Install clip on nut over the bolt hole at
Reference A on the Dash Support Bracket.
Dash Support
Bracket (14)
B.
Remove the bolt from the hole at Reference A.
Remove the existing dash bracket and replace it
with the one furnished in this cab.
C.
Replace the bolts except for Reference A. Do
not tighten the bolts at this time.
Figure 4
6
