Step 12; See Figure 12A, 12B & 12C:
Install Rubber Door Seal. Cab frame / Door
alignment.
Figure 12A
IMPORTANT !
The ‘U’ shaped section of the rubber door
seal will be applied to the edge of the door.
The ‘tube’ shaped section of the rubber
door seal should be between the doorframe
and the cab fram
e.
The use of a rubber mallet is recommended
to gently seat the seal onto the doorframe.
A.
Cut two 63” pieces of rubber door seal.
Allowing about a free inch to tuck behind the top
panel’s over lap, start pressing the ‘U’ shaped
section of the rubber door seal onto the edge of the
door frame. Follow the doorframe across the top
edge and down along the leading edge of the
doorframe. There will be some excess past the
doorframe.
B.
Cut out the section of “tube” between the
arrows to prevent the Latches from binding.
Repeat the above steps on the other side.
Figure 12B
C.
Place an 8” piece of adhesive Velcro
®
in place
as shown to attach the door flap on left side.
D.
Close the Doors and latch them. Adjust the
latches and hinges as needed to align the Doors.
E. Tighten all of the cab frame bolts left
loose in previous steps. Remove the Doors
by lifting them up and out of the bottom
hinges.
IMPORTANT !
Clean the area where the adhesive hook
Velcro
®
is to be applied. Remove all dirt and
oil then wipe with the alcohol pads
provided.
8” Velcro
®
Figure 12C
11
