Toro 07263, Руководство по установке

Страница: 1 / 8

Form No. 3364-459 Rev A
Electric Bed Lift Kit
Electric-Powered Mid-Duty Workman ® Utility Vehicle
Model No. 07263—Serial No. 310000001 and Up
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Prepare the Machine
Lift bracket, upper 1
Flange head screw (5/16 x 3/4 inch) 4
Lift cylinder support 1
Lift actuator 1
U-bolts 2
Flange nut (3/8 inch) 6
Carriage bolts (3/8 x 3/4 inch) 2
Clevis pin 1
2
Cotter pin 1
Install the bed lift
Solenoid 1
Bolt (#10 x 3/4 inch) 2
Nut (#10) 2
Accessory harness 1
Switch 1
Clevis pin, large 1
3
Cotter pin 1
Install the switch
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
1. Position the machine on a level surface. Set the
parking brake, turn the ignition off, and remove the
key.
WARNING
If you leave the key in the ignition switch,
someone could accidently start the machine and
seriously injure you or other bystanders.
Remove the key from the ignition switch before
you do any maintenance.
2. Raise the bed. Rotate the latch rod upward and raise
the box with the other hand.
3. Raise the box to its full height; then lower it slightly
to engage the prop rod (Figure 1).
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved