Toro 07263, Руководство по установке

Страница: 2 / 8

WARNING
A raised box could fall and injure persons that
are working beneath it.
• Always use the prop rod to hold the box up
before working under the box.
• Remove any load material from the box
before raising it.
Figure 1
1. Prop rod
4. Remove a short battery cable linking any two
batteries in the battery bank to remove power from
the system (Figure 2).
Figure 2
1. Short battery cable
5. Remove the 2 flange head screws securing each side
of the latch rod bracket to the underside and front
face of the box (Figure 3). Retain all parts for future
use.
Figure 3
1. Latch rod bracket 3. Flange head screw, inside
front face of box
2. Latch rod 4. Flange head screw,
underside of box
2
Installing the Bed Lift
Parts needed for this procedure:
1 Lift bracket, upper
4 Flange head screw (5/16 x 3/4 inch)
1 Lift cylinder support
1
Lift actuator
2 U-bolts
6 Flange nut (3/8 inch)
2 Carriage bolts (3/8 x 3/4 inch)
1 Clevis pin
1 Cotter pin
Procedure
1. Remove the screws from the braces on the underside
of the box in the positions shown in (Figure 4).
2. Mount the upper lift bracket to the underside of the
box with 6 flange head screws (5/16 x 3/4 inch)
from loose parts and removed previously. Position
the bracket as shown in Figure 4.
2