Toro 07263, Руководство по установке, Страница: 4 / 8

Figure 7
1. Solenoid plate 5. Nut, #10
2. Solenoid, existing 6. Accessory harness
3. Solenoid, new 7. Large posts
4. Bolt, #10 x 3/4 inch 8. Small posts
3. Attach the accessory harness to the solenoid.
Connect a large ring to each large post. Connect a
small ring wire to each small post. Secure the wires
with the existing fasteners.
4. Locate the optional 48v output connector as labeled
on the main harness and remove the cap. Connect
the accessory harness to the 48v output connector as
shown in Figure 8.
Figure 8
1. Dash, under side
6. Box lift kit connector, from
main harness
2. Main harness 7. Box lift kit connector, from
accessory harness
3. Accessory harness 8. Cap 48v connector
extension, from accessory
harness
4. 48v connector, from main
harness 9. Switch connector
5. 48v connector, from
accessory harness 10. Plug in dash
5. Locate the box lift kit connector on the main harness
and remove the cap. Attach accessory harness to box
lift kit connector. wire from main harness.
6. Cap 48v output connector on accessory harness.
7. Place the switch connector into position behind the
plug in the dash as shown in Figure 8.
8. Remove the plug from the hole in the right side of
the dash (Figure 9).
9. Plug the switch into the accessory connector in the
dash. Insert the switch into the hole in the dash
(Figure 9).
Figure 9
1. Plugged hole 3. Cut new hole (if required).
2. Switch
WARNING
Loose or improperly secured battery connections
could damage the vehicle and cables causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
Always ensure the battery polarity when making
connections.
10. Plug the switch into the harness connector in the
dash. Insert the switch into the hole in the dash
(Figure 9).
11. Replace the short battery cable removed previously.
Torque the nuts securing all battery cables to 120 to
180 inch-lb (13.5 to 21 N
⋅
m).
12. Coat the battery terminals with Toro battery terminal
protector.
13. Press the switch upward to extend the actuator rod
until it is aligned with the mounting holes in the
4