Toro 07068, Руководство оператора

Страница: 14 / 36

8
Connecting the Hydraulic
Hoses
No Parts Required
Procedure
Connect the hydraulic hoses from the sweeper to the quick
couplers on the tow vehicle (
Figure 13 ).
g03051 1
Figure 13
1. Hydraulic hoses 2. Harness'
Important:
Make sure that the brush rotates in the
proper direction (when viewed from the motor end,
the brush should rotate clockwise). If the brush is
rotating counterclockwise, reverse the hydraulic hose
connections.
Note:
Mark the high-pressure hose with a cable tie to
identify the correct hose installation ( Figure 14 ).
Figure 14
1. High pressure hose 2. Cable tie
9
Connecting the Harness
No Parts Required
Procedure
Connect the harness from the sweeper to the power harness
on the tow vehicle (
Figure 13 ).
Note:
Ensure the harness cannot get pinched in the hitch
and ensure the harness is not on top of or around the hitch
pin.
10
Mounting the Windrow Blades
Parts needed for this procedure:
1 Blade-mounting assembly
1 Bolt (7/16 x 3-3/4 inch)
1 Bolt (7/16 x 3-1/4 inch)
4 Small washer (1/2 inch)
1 Large washer
1 Spacer
2 Locknut (7/16 inch)
1 Chain
1 Bolt (3/8 x 1-1/4 inch)
1 Flange nut (3/8 inch)
1 Snap link
Procedure
1. Secure the blade mounting assembly to the left end
of the sweeper frame with a bolt (7/16 x 3-1/4 inch)
bolt, 2 small washers, a large washer, and a locknut
(7/16 inch).
Note:
Position components as shown in Figure 15 .
2. Secure the windrow blade to the mounting assembly
with a bolt (7/16 x 3-1/4 inch), 2 flatwashers, a spacer
and a locknut (7/16 inch). Assemble the components
as shown in
Figure 15 .
Note:
Position the longer end of the blade away from
the sweeper.
3. Secure the chain to the blade mounting assembly with
a bolt (3/8 x 1-1/4 inch) and a flange nut (3/8 inch)
(
Figure 15 ).
14