g014616
Figure 33
1.
Eccentric
2.
Locknut
B.
Move the functional-control lever to the
N
EUTRAL
position and the throttle to the
S
LOW
position. Start the engine.
C.
Rotate the eccentric until creep does not
occur in either direction. When the wheel
stops rotating, tighten the nut locking the
eccentric and the adjustment (
).
Verify the adjustment with the throttle in the
S
LOW
and F
AST
position.
Note:
If the wheel still turns when the
eccentric is at the maximum adjustment,
contact your authorized Toro distributor
or refer to the
Service Manual
for further
adjustment.
Adjusting the Transport
Speed
Obtaining the Maximum Transport
Speed
The traction pedal comes adjusted for
maximum-transport speed, but you may need
to adjust it if the pedal reaches full stroke before it
contacts the pedal stop, or if you want to a decrease
the transport speed.
To obtain the maximum-transport speed, put the
functional control lever in the T
RANSPORT
position and
press down on the traction pedal. If the pedal contacts
the stop (
) before you feel tension on the
cable, perform the following adjustment procedure:
g015494
Figure 34
1.
Pedal stop
1.
Put the functional-control lever in the T
RANSPORT
position and loosen the locknut securing the
pedal stop to the floor plate (
).
2.
Tighten the pedal stop until it does not contact
the traction pedal.
3.
Continue applying a light load on the transport
pedal and adjust the pedal stop so it contacts
the pedal rod and tighten the nuts.
Important:
Ensure that the tension on the
cable is not excessive or you will reduce the
cable life.
Reducing the Transport Speed
1.
Press down on the traction pedal and loosen the
locknut securing the pedal stop to the floor plate.
2.
Loosen the pedal stop until you obtain the
desired transport speed.
3.
Tighten the locknut securing the pedal stop.
Adjusting the Mowing
Speed
The mow speed is set to 3.8 mph at the factory.
You can adjust the forward moving speed from 0 to 8
km/h (0 to 5 mph).
1.
Loosen the jam nut on the trunnion bolt (
2.
Loosen the nut securing the lock and mow
brackets on the pedal pivot.
35
