Tornado Floorkeeper 28 OB/99128OB, Руководство по эксплуатации и техническому обслуживанию

Страница: 7 / 33

7
Scrubbers equipped with Hydralert™ technology have a sensor on the battery pack and an audio alarm
which monitors and communicates low battery water conditions.
1. When batteries are fully charged and the key is turned on, Hydralert™ will check the water level
•If the audio alarm is not activated, there is sufficient water in the batteries
•An audio alarm means Hydralert™ senses a low battery water level.
NOTE
: Failure to clean the Hydralert™ light pipe will limit Hydralert™’s ability to read the water level
and will reduce battery life.
2. Turn the key off and the fill the batteries with distilled water. (See WET, LEAD ACID BATTERY
MAINTENANCE)
NOTE : Battery packs equipped with Hydralert™ may take more than ½ gallon of water after the
Hydralert™ audio alarm has been activated.
3. After completing the watering procedure, cycle the key to verify the audio alarm is not activated
CLEANING THE HYDRALERT™ SENSOR LIGHT PIPE
WARNING
: Battery posts, terminals, and related accessories contain lead and lead compounds,
chemicals known to the State of California to cause cancer and reproductive harm, and during
charging, strong inorganic acid mists containing sulfuric acid are evolved, a chemical known to the
State of California to cause cancer. Wash hands after handling. For more information go to www.
P65Warnings.ca.gov
WARNING:
Do not wear jewelry when working near electrical components
WARNING:
Batteries emit hydrogen and oxygen gas
- Keep sparks and open flame away. Do not smoke near the machine
- Charge batteries in a well-ventilated area with the battery compartment open
CAUTION: Always wear protective clothing, gloves and goggles when handling and charging
batteries
NOTE:
Failure to clean the Hydralert™ light pipe will limit Hydralert™’s ability to read the water level
and will reduce battery life
1. Remove the cap with the black sensor module being careful not to damage the yellow floats. Do not
remove the black sensor module from the cap assembly.
2. Thoroughly wipe the clear light pipe next to the middle yellow float, paying extra attention to the tip of
the pipe
3. While the cap is still removed, cycle the key and verify the audio alarm activates. Turn the key off
4. Carefully align the cap and press it firmly onto the battery making sure it is fully seated
5. Complete the battery servicing procedures above, cycle the key, and verify the audio alarm is not
activated.
6. The machine is ready for use
An optional item is a Hydralert™ battery water monitoring system. When the battery water falls below an
accepatable level you will hear a audio alarm indicating the batteries need to be watered.