Tornado 98473, Руководство оператора

Страница: 6 / 15

6
GENERAL PRECAUTIONS
•
You must be trained in the operation of
this machine before use. Please read
this manual carefully and obtain
operation instructions from your safety
director or your authorized Tornado
distributor.
•
Always operate this machine with all of
the cable removed from the handle.
Failure to do so will upset the precision
balance of the machine.
•
Do not use Bi-Speed Floor machine for
rotary brush shampooing, scarifying, or
sanding.
•
Care should be taken to keep cable
away from rotating brush.
•
Do not attempt to repair warranted
machines. All repairs must be done by a
qualified and authorized repair center.
Non warranted repairs will be billed
back to the owner of the unit.
•
Do not use any replacement parts
except those specified in the parts list.
Unauthorized parts will void the
warranty and could cause the unit not to
function properly.
FAILURE TO COMPLY WITH THE ABOVE WARNING INSTRUCTIONS
WILL VOID THE WARRANTY
EXTENSION CORD
If an extension cord is used, use only a
three wire 12 gauge extension cord that has
three prong grounding type plugs and three
prong receptacles that accept the machines
plug. Your Bi-Speed Floor machine is
equipped with a 14-gauge power cord.
Replace or repair all damaged cables.
PREPARING THE MACHINE
Your Bi-Speed Floor machine is shipped
complete and ready for use. Remove
machine from pallet and discard bolts. No
further disassembly or assembly is required.
Prior to operation, familiarize yourself with
these operating instructions.
PAD PLACEMENT/INSTALLATION
INSTRUCTIONS
•
Place pad on floor.
•
Place pad holder on pad, bristle side
down-making sure pad overlaps pad
holder uniformly.
•
Turn over pad holder assembly by
grasping pad and pad holder together
(pad holder will not “grab” pad yet).
•
Firmly depress pad with thumbs to
engage Center-Lok mechanism. (Note:
Do not force pad below Center-Lok
bristles.)
•
Mount pad holder assembly on
machine.
ATTACHING BRUSH OR PAD HOLDER
Be sure cable is not plugged into wall outlet.
To attach brush or pad holder raise handle
to upright position and tighten the handle
tube clamp lever. Tilt machine back on
wheels until handle rests on floor. Rotate
brush or pad holder against coupler until the
three lugs drop into place and turn slightly
counter-clockwise until locked. To remove,
turn clockwise until lugs of coupler are free
and then lift off. For long life and best results
always use genuine Tornado accessories.
OPERATING THE BI-SPEED
FLOORMACHINE
•
To adjust handle to desired height,
loosen clamp lever, adjust handle to
desired height and tighten clamp lever.
•
Plug cable to wall receptacle making
sure the voltage and cycles correspond
with that indicated on nameplate.
•
THE LOCKOUT LEVER MUST BE
PUSHED FORWARD FROM THE
OPERATORS POSITION TO UNLOCK
SWITCH LEVERS. Right or left switch
levers will independently operate motor.
•
Raising or lowering handles lightly
controls movement of machine in
operation. Raise handle to travel to the
right. To make it travel to the left, lower
the handle.
•
Low speed used for wet scrubbing and
stripping. Apply cleaning or stripping
solution directly to floor surface with a
mop. Scrub surface with the proper
brush or pad. Be sure the surface does