Tornado 98473, Руководство оператора

Страница: 7 / 15

7
not dry before recovery of solution.
Recover solution with wet/dry vacuum.
•
High speed used for polishing and spray
buffing. Prior to either procedure clean
the floor surface. Polishing or
burnishing is a dry procedure. Use
proper brushes or pads. Spray buffing
with either an aerosol system or hand
held trigger sprayer, the spray buff
solution should be applied away from
the machine. For best results the spray
buff, material should be buffed out within
two to three passes.
DAILY OR REGULAR MAINTENANCE
WARNING : Always unplug the Bi-Speed
Floor machine before cleaning, making
adjustments or repairs.
•
Check the condition of the floor pad or
brush, replace when necessary. Pad
holders and brushes must be properly
maintained to insure maximum cleaning
results.
•
Wipe the entire machine down with a
general purpose cleaner.
•
Raise the handle tube in the up storage
position.
•
Wipe down the cord when wrapping the
power cord for storage. Tuck the last 12”
of the cord through the wrapped cord.
Do not make a knot at the plug end.
•
Store the Bi-Speed Floor machine in an
upright position. Do not store with Brush
and/or Pad Holder mounted on
machine.
•
Check for cable damage and repair if
necessary.
PERIODIC MAINTENANCE
•
Be sure to use Tornado genuine parts
and that an authorized Tornado Service
center provides service.
TROUBLE SHOOTING HIGH SPEED
WOBBLE
Your Tornado Bi-Speed Floor machine has
been tested and found to be wobble free
with the dynamically balanced pad holder
supplied with this machine. If you encounter
excessive wobbling do the following:
1. Check the pad - you will encounter
wobbling if:
A) The pad is thicker on one side then the
other.
B) Using worn or damaged pads.
C) Pad is not centered properly on pad
holders.
D) Using non-approved pad holders.
E) Storing pad and/or pad holder on the
machine.
F) Not storing pad holder and pads properly.
2. New Pad Break-In:
Most new pads need a break in time from 5
to 10 minutes in low speed. This levels and
smoothes the pad out. You are now ready to
use the high speed. CAUTION: If the
machine is left unattended, resting on the
pad for any period of time you may
encounter wobbling. Repeat the above
procedure to smooth out pad.
3. Pad Holder Adjustment:
A) Due to variations, in rubber, the pad
holder may initially cause some machine
wobble.
Heeling machine from side to side will
correct this situation.
B) If the wobbling persists with the above
precautions and procedures, rotate the pad
holder to another lug position. Mark this
position with a marker for future placement.
MOTOR MAINTENANCE
This machine is equipped with a permanent
magnet motor. Check carbon brush wear
after every 500 hours of use. Check carbon
brush wear every 500 hours of use. Replace
when brushes are 3/8” long. Only an
authorized service representative should
replace (Carbon motor brushes.)
TO INSPECT CARBON BRUSHES
1. Unplug cable
2. Unscrew (4) screws at top of motor cover.
Remove motor cover and cover ring.
Brushes (4) are accessible inside large
openings near top of motor.