l
Cold-rolled steel (that's at least 1 in. square)
l
Extruded aluminum (that's at least 1-1/2 in. square)
l
Structural tubing (that's at least 1-1/2 in. square)
2. Open the clamps on both vises with the handwheel and
the clamp handle. Then, load the stock between the
vises as shown in the following image.
Figure 10-17: Stock loaded between the vises.
3. Close the vise with the handwheel until the material is
secure. Verify that the stock is flat against the entire
length of the base casting.
4. Loosen the four M8 socket head cap screws securing the
fixed clamp jaw to the infeed table.
Figure 10-18: M8 socket head cap screws on the fixed
clamp jaw.
5. Secure the stock to the fixed jaw with a clamp.
6. Tap the fixed clamp jaw until it is flush with the side of
the stock.
7. Tighten the four M8 socket head cap screws that you
loosened in Step 4. Verify that the fixed clamp jaw
remains flush with the stock.
8. Remove the clamp from the machine.
9. Remove the stock from the machine.
©Tormach® 2020
Specifications subject to change without notice.
Page 48
UM10538: Tormach AF50 Autofeed Bandsaw (Version 0320A)
For the most recent version, see tormach.com/support
10: MECHANICAL ADJUSTMENTS
