- 26 -
14.
Error status data matrix code:
0 Correct scanning
1 Failure to decode code (erroneous code structure)
2 Error correction depleted (too many errors had to be corrected)
3 Failure to determine the code pattern
4 Failure to adjust corners
5 No square code (if square code was selected)
6 Found an L, but this is not a DM code
7 Found only a line, nothing else
8 Did not find any ramp transition
15.
Error status bar code:
Instead of the print quality parameter the bar width is displayed in the output.
In the event of an error an amplified error code is displayed instead of the bar width.
In a successful scanning the type of code is displayed in the status information if “Status
display” was activated. If auto-discrimination is selected this item enables to find out which
type of code was scanned.
Status identification in case of successful scanning:
11
Code I2of5 start left
12
Code I2of5 start right
21
Code 39 start left
22
Code 39 start right
Status identification in case of erroneous scanning:
8
No code was found
7
Problems with the clear area
6
No code I2of5 or code 39 was found
5
Plausibility check not OK, erroneous structure
4
Incorrect coding
3
Checksum problems
2
Problems with the length
1
Unused
Extended error code in case of erroneous scanning:
1
Clear area left without disturbances is too small code I2of 5
2
Clear area left with disturbance is too small code I2of5
3
Clear area left without disturbances is too small code 39
4
Clear area left with disturbance is too small code 39
5
No accordance with preset code
6
Checksum error code I2of5
7
Checksum error code 39
8
Code length code 39 is erroneous