TOPP C260, Инструкции по установке и использованию, предупреждения

Страница: 26 / 32

ISTRUZIONI PER L’INSTALLAZIONE E L’USO
26
1 2
3
4
5
6
7
8
9
10
INSTALLATION
Open the package and remove the various com-
ponents;
1)With a pencil draw the center line X of the
window frame. Measure the distance D between
the two chain terminals of the actuator and mark
it on the window, symmetrically to the midline X
marked previously, trace axis X1 and X2;
2)Trace axis X1’ and X2’.
Taking as reference the axis X1,X1’ and X2,X2’
previously traced, the hole layout for the appli-
cation and the components dimensions, pag.10,
mark the points for the holes to fasten the
brackets S2 (S4) and SF; with a suitable drill,
create on the window the holes;
3)4)5) Mount the two movable window brackets
S2 (S4) and the SF, with appropriate screws;
6)Insert the two pairs of clamps “M1“, fi tting them
in the actuator slider adjacent to the chain termi-
nal, then close them partially with the screw and
nut in the package; Position the clamps 80mm
on either side of the chain terminal midline and
tighten the screw all the way;Perform the electric
connections according to the provisions as well
as with reference to the wiring diagram. Power
the actuator and let the chain come out for at
least 250mm of stroke, then disconnect electri-
cally the actuator;
7)8)First fasten the UPPER chain terminal to the
S2(S4), fi rst fi t the long side of the shaft and then
insert the entire assembly. Move the square pla-
te to the centre of the mount and hand tighten
bolt A. Now insert bolt B (included) into the fra-
me mount and tighten both bolts down fully with
a 2.5mm hex wrench (torque to 2,3 Nm). Then
fasten the LOWER chain terminal to the S2 (S4),
as described upper.
9)Fasten the clamps M1 to the brackets for
connection to the window SF . Make sure the
brackets for connection to the window are cor-
rectly fastened to their clamps. The number of
clamps necessary for assembly will depend on
the length of the actuator: up to 3 meters only 2
clamps are needed, over 3 meters add a third at
the center of the actuator.
10) Insert the plate hooks PF and the screw.
11) Connect the actuator. Perform a test of com-
plete window frame opening and closing. Verify
that with open window frame, the stroke is some
centimetres lower than the stroke limited by win-
dow frame mechanical limit devices. Once the
closing phase is ended, verify that the window
frame is completely closed by checking the seal
defl ection.
5- INSTALLATION INSTRUCTIONS / FIGURE
C260