TOPP C25, Инструкция по установке и эксплуатации

Страница: 21 / 40

Upstream from the control line a power supply bipolar
main switch must be installed with opening contacts of at
least 3 mm.
&
Before making any electrical connections on the
actuator, make sure it is installed correctly on the window.
& Before making any electrical connections on the
actuator, make sure the power supply cable is not
damaged. If the cable is damaged, then it must be
replaced by the manufacturer through the technical
assistance service or by technical operators.
5.5
CONTROL DEVICES
The control devices used to run the actuator must
provide the safety conditions required by the current
regulations of the country in which it will be used.
Depending on the various types of installations, the
actuators may be operated by the following control
devices:
%
Manual push button: Selector switch button with two
poles and central off position, fitted with "dead man's
switch” control
;
%
Optional: Control and supply unit: Power stations
with microprocessor that control the single actuator or
more actuators simultaneously with one or more
manual buttons, an infrared ray remote control or a
433 MHz radio control. Rain sensors can be
connected to these power stations, a wind sensor and
a brightness sensor;
@
Any power stations used, will have to supply
voltage to the C25 for a maximum time of 120
seconds.
Adjusting the window closure correctly will ensure the
duration and the holding of the seals and will provide a
good functioning of the actuator.
A good method to perform a correct installation consists
in making sure that after closing the actuator the following
carried out:
%
the window seals must be pressed correctly;
%
the actuator chain must be retracted completely.
If the actuator chain is not retracted completely, there
would be no limit switch intervention when the chain
retracts. In this situation, the actuator's motor stays in a
maximum strain condition until the electronic protection
intervenes and until the acoustical warning “BUZZER”
activates, which emits a continuous “beep” sound until
the actuator remains connected to the power supply. This
extra safety system was made to provide a quick system
to identify any abnormalities when mounting the
appliance. Still, it is mandatory to abide by all the
5.6
ADJUSTING THE WINDOW
CLOSURE
21
EN C25
installation procedures described on this manual.
Therefore, in both of these situations it is necessary to
adjust the position of the actuator once again by
proceeding in the following manner (
Fig. 28 ):
1 . disconnect the power supply;
2 . fit the self-tapping screws TC d6.3x38 (included in
the package) into the central hole of the fist clamping
insert;
3 . use a suitable screwdriver and bring the screw into
contact until removing the insert completely;
4 . remove the second clamping insert by repeating the
procedures on point 2 and 3.
5 . adjust the position of the actuator;
6 . fit the both of the inserts once again.
5.7
EMERGENCY PROCEDURES
If the window must be opened manually due to lack of
electricity or because the mechanism locks, follow the
instructions below:
%
Top hung opening: Fig. 29- pull the release push
bottom of the quick coupling to the direction indicated
by the arrow and rotate the actuator upwards until it
disengages from the quick coupling.
%
Bottom hung window opening: Fig. 30 - Put a cut
screwdriver between the bottom hung window
bracket and the chain terminal and lift up until the
chain terminal is disengaged.
Before performing any type of intervention on the
actuator and on the window the following must be done:
%
disconnect the branching device from the power
supply network;
%
to avoid unexpected start-ups, lock the branching
device's main switch that is installed on the power
supply line; if the main switch cannot be locked, a “do
not operate” warning sign must be affixed.
INSTALLATION AND USE INSTRUCTIONS