Topp Music Gear MX.10 USB V2, Руководство пользователя

Страница: 7 / 20

CONTROL ELEMENTS
7- 75 Hz Low-Cut Switch (MX.10/USB V2, MX.12/USB V2 only)
8- +4/-10 Switch ( only) MX.10/USB V2, MX.12/USB V2
9- AUX Send (except MX.5 V2)
These switches are used to select the input sensitivity of the
line inputs on the stereo channels. +4 dBu is suitable for
professional audio devices and -10dBv is suitable for general
devices. If not sure to use which setting, try +4 dBu first,
then change it to -10dBv if the volume is too small to be
satisfied.
By pressing this button you will activate a 75Hz low frequency
filter that cuts the bass frequency below 75Hz. You can use this
switch to reduce the hum noise caused by the mains power
supply, or the stage rumble while using a microphone.
This control is used to feed the mono input of parallel effects
devices or the input of a stage monitor amplifier via the AUX
SEND output jack. All the channel controls (except PAN or BAL)
will affect the AUX signal. The signal is tapped off after the LEVEL
control. The output from an external processor can come back
via STEREO AUX RETURN inputs(on the MX.6/USB V2) or stereo
channel (MX.10
MX.12 ), and be added to the main mix. /USB V2, /USB V2
6- LOW EQ
This is the bass control. It is used to boost male voice, kick-drum
or bass guitar. Your system will sound much bigger than what
it is. The gain range goes from -15 dB to +15 dB and the center
frequency is 80 Hz.
8
9
10
11
12
10- PAN/BAL
Abbreviation of PANORAMA control for mono channels, for the stereo channels, always says,
BALANCE control. You can adjust the stereo image of the signal via this control. For mono
MIC/LINE channels, keep PAN control in centre position and your signal will be positioned in
the middle of stage that is to say the mono signal appears equally in both sides. Turn this
control fully counterclockwise and the signal will be present only on the left speaker and
vice-versa. For stereo channels, by rotating the BAL control, you can attenuate the signal of
left or right. It means if turn the control to left, the right channel will be attenuated; if turned
to right, the left channel will be attenuated.
11- PEAK LED
When this LED blinks, it warns you that you are reaching signal saturation and possible distortion.
From this LED you can adjust the correct level, not too strong to cause distortion and not too weak
to be lost in noise.
7
9
10
11
12
7
5