Notice Ecotop - Page 3 - Wind of Change
THANK YOU
for your purchase of the RC electro sailplane
Wind of Change !
We made a main effort while drawing and building this electro sailplane so that it is the best model you ever built and fly.
We provide you a kit with the highest quality and the best possible performances.
We wish you a great success while assembling and flying your new
Wind of Change.
The success of our Krasivo and Krasivo 2 led us to design and to offer the Wind of Change, which is an extrapolation with a 4-meter
wingspan. The easy to control of Krasivo 2 was preserved, but we allow you to access to a higher class size, giant sailplane with a
model which remains able to be landed everywhere, with his wide flaps which can be used as airbrakes in butterfly mode.
Wind of Change key features
●
The sheeted foam wing is reinforced with glass fiber.
●
The glass fiber fuselage is reinforced with carbon in all the tail boom, and is really strong.
●
The powerful motor make possible to fly without a tug plane and makes it safe to fly at slope. Climb rate : 7 to 8 m/s !
●
Stab is removable for easy transportation and storage.
●
And of course... the model is delivered fully assembled and covered, you just have to make final assembly, install the radio system
and the motor.
With the Wind of Change, you can practice soaring on flat fields as well as for slope soaring. Flying is easy and if you fly with at
ease a 2.5 or 3 meters glider with ailerons, you can fly the Wind of Change. Your first ideal 4-meter span !
Additional informations :
●
Double dihedral on the wing make easy to stay in thermals.
●
The long tail lever arm provides a good stability and make the rudder management easy.
●
Flaps allow to optimize the flight within the whole domain of flight.
●
The thin SD 7080 airfoil permits to fly in quite strong wind.
IMPORTANT :
Please take a few moments to read this instruction manual before beginning assembly. Do an inventory of the parts using the main
and additional parts list (see pages 5, 7, 11, 14 and 16), to control that there is no lack or imperfection.
Thank you to contact TOPMODEL immediately, if you note a missing part or a damaged part.
WARRANTY :
It is important to notify to TOPMODEL all damage or problems with this model within 7 days following the reception of the kit to be able
to benefit the warranty. In the event of return of the model, the customer is responsible for transport and return shipping cost is at his
expenses. In the event of defect, the part will be exchanged or replaced once this one will be delivered to TOPMODEL for expertise
(transport on your cost). In the event of problem, do not hesitate to contact TOPMODEL.
TOPMODEL cannot control the dexterity of the modeler and cannot influence the builder during the assembly or the use of this
radiocontrolled model, thus TOPMODEL will in no way accept or assume responsability or liability for damages resulting from the use
of this user assembled product.
The purchaser/user accepts all the responsibilities in the event of structural or
mechanical problems.
To assemble this kit, you’ll need the items listed below:
●
ADHESIVE :
Cyanoacrylate thin and thick, epoxy 30’ and 5’ adhesives.
●
TOOLS :
Knife (X-acto), Phillips screw driver (small and medium), needle tip pliers, pliers, scissors, scotch tape, masking tape, double
sticking tape, drill (bits all size set), sanding paper, ruler, ball point pen, clips, alcohol, soldering iron, piece of cloth or rags, etc.
TO ASSEMBLE THIS KIT
REMINDER
We take great care to delivering the best possible quality.
We kindly remind you that these models are not ready to fly and that the remaining work is an important part to get the
model flying. For this, please, check all glue joints and assemblies.
Safety first !
We thank you for your attention during the assembly of our kits, and wish you good and numerous flights !
TOPMODEL SAS
