Topens CASAR HJ4021, Руководство пользователя

Страница: 27 / 33

24
How to Operate
The user can operate the opener once all adjustment setting is finished.
With the gate in its fully closed position, press and release the remote control, the gate will move to the
programmed opening position and stop.
With the gate in its fully opened position, press and release the remote control, the gate will move to the
programmed closing position and stop.
While the gate is moving, press and release the remote control, the gate will stop immediately. The next
command from the remote will drive the gate to the opposite direction and the gate will stop at its
programmed opening/closing position.
The gate will stop in case of obstruction during opening. The command from the remote control will drive the
gate to the opposite direction and the gate will stop at its programmed closing position.
The gate will reverse in case of obstruction or stall force during closing, and it will move to the programmed
opening position.
Maintenance
Warning: Disconnect power before servicing.
1. Using a clean, dry cloth, wipe the gate opener shaft, and then apply a silicone spray to reduce its friction.
In cold climates where temperatures reach 1°C (30°F) or less, spray silicone on the actuator every 4~6
weeks to prevent freeze up.
2. Regularly check gate hinges to make sure gate is swinging smoothly and freely. Grease hinges if
needed.
3. Check your installation periodically, as hardware and posts will shift. Brackets may need to be adjusted
or hardware may need to be tightened.
4. Maintain the area around your gate. Keep the areas free of objects that can prevent the gate swinging
freely.
NOTES:
1. Inspection and service should always be performed anytime a malfunction is observed or suspected.
2. Refer to chapter “setting of the control board” in the instructions on how to check gate force and sensitivity
adjustments.
Trouble Shooting
Symptom Possible Solution(s)
The opener does not run. LED
is OFF.
1. Check the voltage of the power supply. It should be 230Vac
±
10%.
2. Check the fuse in the control board. Replace the fuse if it was burnt
out.
3. Check the control board. Replace the control board if necessary.