Topens CASAR HJ4021, Руководство пользователя

Страница: 18 / 33

15
CAUTION: Install the Control Box in a well-ventilated place protected against rain and sunlight.
CAUTION: Make sure that the cable outlet hole in the Control Box is always down during installation, so as
to drain off the water.
Step 3
Insert the cable of the second gate opener and warning light cables into the control box through middle
strain relief. Then repeat step 2.
Step 4
Insert the cables of the optional parts into the control box through the right strain relief. Then repeat step 2.
Connection of Power Supply
WARNING: NEVER connect the gate opener to the power
supply before all the installations have been done.
Connect the power supply to the Control Box refers to the following
illustration.
NOTE:
1. Use copper conductors to connect to the power supply terminals.
2. The wire (not provided) size should be at least 18AWG (0.75mm
2
)
which is intended to connect the power supply.
3. Run the wires in conduit to the control box to prevent damage to
the wires from lawn mowers, weed eaters and grazing animals.
4. The fuse in the control board is interchangeable. A 10a, 250vac, Φ5*20mm fuse is suitable to the control
board.
Connection of the Control Board
Motor connection for PULL-TO-OPEN
Actuator 1
Insert the stripped cable wires into the appropriate terminals
on the opener terminals block. The red wire should be inserted
into the
“MOTOR 1+”
terminal, the black wire into
“MOTOR
1-”.
NOTE: For dual gate mode, actuator 1 must be used for
master gate. Master gate would open first and close last.
Actuator 2
Similar as the connection of
Actuator 1
, insert the stripped cable wires into the appropriate terminals on
the opener terminals block. The red wire should be inserted into the “MOTOR 2+” terminal, the black wire
into “MOTOR 2-”.
Connection of the actuator for “Push to Open” is different from the connection for “Pull to Open” . The
connection of the actuator for
“Push to Open”
must be referred to the figure on the right.
Black wire should be inserted into the “Motor+” terminal. Red wire should be inserted into the “Motor-”
terminal.