Setup and Survey
HiPer XT Operator’s Manual
3-10
3. Check the STAT light for tracked satellites.
4. Connect your receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-10 for this procedure.
5. Click
Configuration
Receiver
.
6. Click
Set all parameters to defaults
(Figure 3-6).
Figure 3-6. Set All Parameters to Defaults
7. On the
Receiver Configuration
screen, click the
MINTER
tab and
specify the desired settings. Refer to the
PC-CDU User’s Manual
for more information.
8. Click the
Positioning
tab and set the Elevation mask parameter to
15 (Figure 3-7), then click
Apply
.
Figure 3-7. Configure Receiver Positioning – Elevation Mask
Содержание HiPer XT
