Topcon HiPer XT, Руководство оператора, Страница: 73 / 100

Radio Configuration
P/N 7010-0713
2-41
Figure 2-25. GSM Tab
7. Click the Serial Interface tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
8. Click Apply , then click on File and select Disconnect . If you
want to close the program, click File -> Exit .
9. Launch PC-CDU and set up the receiver to run as an RTK Base
Station. For how to set up an RTK Base using PC-CDU, refere to
your receiver’s documentation or
PC-CDU User’s Manual .
Configuring a Rover Station’s GSM
Module with Modem-TPS
NOTICE
NOTICE
To comply with RF exposure requirements, maintain at
least 25cm between the user and the GSM radio modem.
1. Repeat steps 1-4 from page 2-27.
When finished configuring the GSM module, always disconnect
from Modem-TPS before exiting to prevent conflicts with serial
port management.
2. Click the GSM tab.
3. In the Mode control, select Master .