Configuration
HiPer XT Operator’s Manual
2-30
9. From the
Output Power
control, select the level of RF transmit
power from 10 mW to 2 W.
Figure 2-20. Radio Link Tab
10. Click the
Serial Interface
tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
Figure 2-21. Serial Interface Tab
11. Click
Apply
, then click on
File
and select
Disconnect
. If you
want to close the program, click
File
->
Exit
.
12. Launch PC-CDU and set up the receiver to run as an RTK Base
Station. For how to set up an RTK Base using PC-CDU, refere to
your receiver’s documentation or
PC-CDU User’s Manual
.
Содержание HiPer XT
