13
CORDLESS IMPACT SCREWDRIVER
EN
Translation of the original instructions
The LED Light on the Charger
Charger (Opt.)
Charger
Power On (Green light flashes slowly)
Battery Low (Red light stays illuminated)
Battery charged 80% (Green light flashes rapidly)
Battery charged 100% (Green light stays illuminated)
Battery Pack temperature is too hot or too cold (Red light flashes slowly)
Battery Pack malfunction (Red and Green lights stay illuminated)
1. Charger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack and the red
Indicator light is “blinking”. When the battery pack temperature returns to between 0°C(32°F) and
50°C(122°F), The charger will automatically begin charging.
3. If both red and green indicator lights are “ON” the battery pack either does not comply or is defective. Please
contact your retailer.
4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. Do not charge battery pack when environment temperature is below 0°C (32°F)or above 40°C(104°F)
6. While charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in the room for one hour
to warm up before starting the battery pack.
7. Remove the plug after finishing the charge.
8. The charger should be cooled at least one hour after continue charging three times.
9. Do not use generator for charging the battery pack.
TOOL OPERATION
Installing or Removing Bit (Impact Driver)
Always be sure that the machine is switched off and the battery pack is removed before installing or removing the bit.
1
2
Fig.4
1
2
Fig.5
Forward
Reverse
Fig.6