Top Tronic T1151, Инструкция по эксплуатации

Страница: 13 / 28

OPERATING INSTRUCTIONS
Leads Connections
The Test Leads are color coded for easy use. These testers only use 2 leads
which are located on both back extremities of the front panel.
The user can vusualy check these connections at any time.
FUNCTIONS
When Depressing the "ON-TEST" Button, the
Instrument starts up or Resets.
Please Note:
If after a test, no key is depressed for ± 5
minutes, the Instrument will switch off
automatically.
You can turn OFF the Tester without having to
wait for Auto-off. To Turn-Off and switch OFF
the Tester immediately, Depress the 1kV key for 5
Seconds. If a test is still in Progress, pressing 1kV
will stop the test.
In this case you need to press 1kV for 5 Sec
again.
The Batteries are tested automatically at start up
The current Drawn from the batteries is about
300mA.
While current is drawn, the total battery voltage is
measured and displayed.
Note that battery voltage is always monitored
during use of the instrument. Should the battery
become too low, the low battery symbol will be
displayed.
Ac and Dc voltages are automatically detected
and shown. This is the default function of the
Instrument. The Voltmeter is selected by default
by the Instrument. The voltmeter is activated
before any test start and the user must connect
the test leads to any circuit before starting any
test. This ensure complete safety to the user and
the Instrument. Should voltage be present on the
circuit under Test, this SAFETY VOLTMETER will
warn the user of the danger.
1000V
To Switch Instrument OFF
DEPRESS for more than 5 Sec
AUTO-OFF
ON/TEST
Batteries are Tested during
start-up of the Tester.
During this Battery Test, a
larger than average current
is drawn. The worst cast
Battery Voltage is seen on LCD.
Voltmeter ac-dc is
automatically selected after
starting
the tester and if voltage is
present on the test leads
before any test. Follow
instructions on the display.
-11-
AUTO-OFF