Fix the carbon fiber tube to one side of the stab
with screws.
Glue the wooden block to each side of the stab tube as below, put the stab
tube into one side the horizontal to the end and mark it out at the root of
the horizontal, drill a hole in the stab tube and horizontal as illustration.
5mm
5mm
15mm
15mm
Screw (2.6x12mm)
2
2
Washer(3x8mm)
1.5mm
1.5mm
Screw (2.6x12mm)
Washer(3x8mm)
Screw (2.6x12mm)
Washer(3x8mm)
The sketch map after the servo and linkage connect.
Screw (2.6x12mm)
Washer(3x8mm)
1.5mm
Screw (2.6x12mm)
2
2
Washer(3x8mm)
Make sure hinges are
mounted in the same line.
3
pivot & round hinge(5x68mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Stab carbon fiber tube(14x423mm)A
Stab carbon fiber tube(14x213mm)B
Assemble the stab to the fuselage drill a hole to
the other section stab.
Epoxy the pivot & round hinges to the rudder.
Epoxy the rudder to the vertical fin.
27
28
29
30
32
6
31
