Electric retract system
Receiver
4.8V
For receiver
In order to let the customers have
more choices, we don't provide a
uniform plugs.
.
Assemble the electric retracts to the plane
after several times smoothly running.
Thank you very much for purchasing our TRCM optional electric retract set,
all our products were passed strict QC before they shipped out to the customers.
In order to avoid probably trouble happen, we still would like you to follow the steps
below before you assemble our electric retracts to your plane.
1
. Connecting the circuit board to the battery and receiver.
2
.
Turn on the radio control to check the
on the circuit board, if the lights turn on gr
or turn on red orderly
，
from the right to the left and all the lights
turn off after 15 seconds, then the circui
work normally. Otherwise the circuit will
defective one if you make sure the setting
your radio control are correct, please do
it but contact with your supplier in time.
3
.
Link the electric retract units to the
circuit boards after the above two
steps, check again the electric retracts
to see if they can work normally or not.
1
Please don't ceaselessly turn and off the switch in 2 seconds,
if you do this way, the circuit board will be heated.
2S - 8.4V
4
The M-mode buttom can be used for
testing the e-retracts without remote
control nor receiver.
Controller
M- mode
Li-PO
For retracts
Bra
ke
R
etr
act
Bra
ke
R
etr
act
w
w
w
.t
o
p
rc
m
o
d
el
.c
o
m
-+
2S
-8
.4
V+
-
TopRCModel-USA.com
