Top Craft TAC-18/3, Руководство пользователя

Страница: 13 / 32

Topcraft 13
Turn the ring of the chuck counter-clockwise in order to open the bits.
• Insert the drill or the bit chosen until it touches the bottom of the chuck.
• Close the chuck clockwise while turning the ring. During this operation, make sure
that the drill or the tip bit is correctly centered compared to the axis of the chuck.
• Make sure that the drill or the bit is sufficiently tight before beginning work.
Attention! During the changing of a tool, installation of the battery, and
transportation or storage of the drilling machine, keep the rotation direction
switch in the middle position (locking of the trigger).
Remove the battery before working on the drilling machine,
Starting
• Choose the rotation direction needed, using the reverser located above the On/Off
switch.
• Drilling machine will not function if the reverser is in the middle position.
• Clock wise direction must be used for the operations of drilling or screwing.
• Counter-clockwise direction must be used for the operations of unscrewing.
• Choose the couple desired using the ring located before the chuck.
• A weak torque must be selected for the operations of screwing in a soft material or
when small screws are used.
• A high torque must be selected for operations of screwing in a hard material or when
large screws are used.
• If the adjustment of the torque is correct, the machine stops automatically when the
screw is level with the material.
• To obtain a good adjustment, proceed by successive tests. Always start with a weak
couple and increase it gradually, until obtaining the desired result.
• For the operations of drilling, place the ring on the position “drill”.
• Choose the speed 1 or 2 using the selector on the top of the machine:
•
Position 1 = Slow speed
• Position 2 = Fast speed
• Insert the battery correctly in its housing. Begin work while pressing on the On/Off
switch.
• This drilling machine is equipped with an electronic switch making it possible to select
the speed best adapted to the specific work you carry out. While pressing slightly on
the trigger, the drilling machine turns slowly. By increasing the pressure on the trigger,
speed increases. It is recommended to always start with a low speed.
• Never change the direction of rotation when the engine is turning.
• To stop the drilling machine, release the On/Off switch: the chuck is slows and
immobilized instantaneously.
6. MAINTENANCE
• Take care of your tools by cleaning regularly. This will ensure a perfect operation and
a long working life.
• During utilization and at the end of work, carefully clean the machine’s ventilators
• Only clean with a warm, damp rag and a flexible brush.
GB