Toolex 597076, Инструкция по эксплуатации

Страница: 11 / 16

11 / 16
11
“ ” means MMA welding,
when you chose this welding mode,
please plug the welding plug with
cable to the TIG control socket (refer
to page 9, (1)).
“ ” means TIG welding, when
this TIG welding mode is selected,
please plug the TIG torch control cable
in to TIG control socket (refer to page
9, (1)).
OPERATION
Note: Before beginning, please read and
understand all the safety precautions
staring on page 1 and especially the
section “Specific Safety Rules” starting on
page 3.
1. Put the metal to be welded on the
metal weeding-cutting table. Ensure
the metals to be welded are clean, so
good welding efficiency can be
promised.
2. Place the TIG welding unit no closer
than six feet from the workpicece to be
welded
3. Connect the TIG torch control, cable
plug, and gas outlet hose as shown on
page 9. Twist to lock in place.
4. Plug in the Grounding Cable into the
Ground Connector on the lower left of
the unit front. Twist to lock.
5. Securely place the clamping end of
the Grounding Cable Clamp to a part
of the workpiece or metal table that is
clean of paint, oil, or dirt. Clamp as
close as possible to the workpiece
without damaging the cable during
welding.
6. Assemble the desired accessories and
rod inside the tip of the TIG Torch
handle.
a. Unscrew the Ceramic Nozzle (6A)
on the Torch Handle (4A).
b. Unscrew the Collect Housing (5A).
c. Place a 5/32” prepared tungsten
welding rod (not included) into the
torch.
d. Screw the Collect Housing and
Ceramic Nozzle back onto the
Torch.
7. Connect a hose and coupling from
the gas regulator on an Argon gas
tank (none included) to the Argon
Gas Inlet on the back of the unit.
Follow
the gas cylinder
manufacturer’s instructions for set-up
and use.
8. Verify that the Power Switch is in the
off position, then plug the 220V~line
cord plug into an appropriate
220V~outlet.
9. When everything is in place for
welding, press the Power Switch UP
to the ON position. The Power Light”
will illuminate, but the
Torch is not yet energized.
10. Press the torch and orient yourself to
one side of the area to be welded,
and move the Welding Helmet Face
Shield (not included, see page 4 item
7) over your eyes.
11. Caution : The Torch handle is now
energized. Be careful not touch
anything else with the Torch except
the workpiece to be welded.
DANGER! To prevent serious injury
and death: The TIG Welder will
immediately turn on when the
trigger is held down.